STL for Pavo20 Pro DJI O3 Canopy Bracket camera mount

Tilt 10-30 degees

i Print in TPU

direct m2 screw from frame to this bracket

Print Upside position Is better for me > less support needed.

If you need clean and nice looking on top area, you can print normaly but with Note : you may need more support and need Use support Blocker or do not use support on 4 holes for screwing bracket to frame ( see at the latest picture highlights )

this is just my reccomendation. because hole is to small , so if use support in this area, it will make hard to remove support after printing.